I am placing a kill password when I write the tag but when I want to kill over the tag I put the same password but it generates an error.
Tag Encoding :urn:epc:tag:sgtin-96:3.0607766.054102.18385
Pure Identity :urn:epc:id:sgtin:0607766.054102.18385
Legacy :gtin=00607766541022;serial=18385
Hexadecimal :307425185834D580000047D1
Binario :001100000111010000100101000110000101100000110100110101011000000000000000000000000100011111010001
^XA
^RS4
^MMT^PW812^LL0102^LS0
^FO25,36^ADN,18,10^FDDrinking Water Agua Purificada^FS
^FO580,36^BQN,2,3^FDMM,00607766541022*Drinking Water Agua Purificada^FS
^FO25,58^ADN,18,10^FDRFID - TAG^FS
^FO25,78^ADN,18,10^FDSerial:018385^FS
^FO25,103^ADN,18,10^FD00607766541022^FS
^RFW,H^FD307425185834D580000047D1^FS
2 Replies
Hi Dennis,
What printer are you using for your implementation? The ZPL RFID commands are dependent on Zebra printer model, please, check the link below to verify compatibility.
https://www.zebra.com/content/dam/zebra/manuals/printers/common/program…
Here, below a link where you can select the right RFID manual for the right printer.
RFID Programming Guide for Zebra Printers | Zebra
For example, if you are using a ZD500R model, please, check the link below for the right RFID manual, and take a look at pages 60, 61, 62 & 63 for knowing how to use ^RL command for kill password.
https://support.zebra.com/cpws/docs/ait/KA_files/8973/rfid3-pg-en.pdf
Thanks,
MC
Hello Dennis,
As you can see on a page 392 of ZPL manual, to set a killswitch password the ^RZ command requires you to use K flag instead of E:
https://www.zebra.com/content/dam/zebra/manuals/printers/common/program…
It looks like there is no L flag for ^RZ command. Please check all your commands and respective options with mentioned document.
Also you may need to check if ^RZ command is supported in a version of your printer firmware.
Dmitry Prokhorov
Software Engineer, Kutir Mobility
Posted on behalf of Zebra Technologies