using this link below as a test of the ZPL code
How to Preview a ZPL Label with a Network Printer
Entered the following into the preview.
CT~~CD,~CC^~CT~
^XA~TA000~JSN^LT0^MNW^MTT^PON^PMN^LH0,0^JMA^PR4,4~SD15^JUS^LRN^CI0^XZ
^XA
^MMT
^PW812
^LL0812
^LS0
^FT22,40^A0N,28,28^FH\^FD$TEXT1$^FS
^BY2,3,62^FT21,119^BCN,,Y,N
^FD>:$TEXT2$^FS
^PQ1,0,1,Y
^XZ
the above was created with the ZebraDesigner software and saved to file.
when run, the preview shows a file name with .prn extension.
Why is the preview not working?
thank you.
3 Replies
Hello Ronald,
How exactly did you name your file? Does it has a ".zpl" extension?
Unsure it will work in case your file has a ".prn" extension.
As you can see in article, there is a ".zpl" extension used.
Hope it helps.
Dmitry Prokhorov
Software Engineer, Kutir Mobility
Posted on behalf of Zebra Technologies
the output was a file ending in .prn.
I did file > print and checked file.
how do I get a .zpl file instead?
I went to this website and tested the ZPL from the .prn file.
http://labelary.com/viewer.html
the result was successful.