I get this error message when I attempt to run the FirmwareUpdateActivity.apk after upgrading my device to 061615. Anybody else seeing this?
"Unfortunately, Firmware Update App has stopped"// Expert user has replied. |
Subscribe to email updates
Monthly updates from our Zebra development team, straight to your inbox.
5 Replies
Folks,
Not sure what to say... When in doubt, do a Factory Reset and then try and run the APK.
David
David, I have tried running a EnterpriseReset, FactoryReset, and FullFactoryReset. I continue to get the error whenever attempting to run the APK.
Has the upgrade procedure and this APK, been tested on rev A and B devices?
Tom and team,
I thought my instructions say the Scanner FW Update APK was ONLY for Rev C.
Yep... just checked... for Rev C Only.
That would do it.
David
I did not and have not seen this and have run it a couple times now. I know we were just told we no longer had to disable DataWedge before running the APK but did you stop it before running the APK?
Yes, I followed the update procedures that David Singer posted. I'm disabling DataWedge before running the APK. The device successfully upgraded to 061615 but I'm not able to run the apk...