Hello to everybody,
 
I'm facing problems during printing and encoding SmartTrack Impinj Dogbone label (which offer 3kbit user memory) with a Zebra ZT410R printer.
I tried the following ZPL command:
 
^XA
^RS8,,,1
^RFW,H,0,300,3^FD000000000011111111112222222222333333333344444444445555555555666666666677777777778888888888999999999900000000001111111111222222222233333333334444444444555555555566666666667777777777888888888899999999990000000000111111111122222222223333333333444444444455555555556666666666777777777788888888889999999999000000000011111111112222222222333333333344444444445555555555666666666677777777778888888888999999999900000000001111111111222222222233333333334444444444555555555566666666667777777777888888888899999999990000000000111111111122222222223333333333444444444455555555556666666666777777777788888888889999999999^FS
^FO50,50^ADN,36,20^11111111^FS
^PQ1
^XZ
 
After reading back the data are truncated and are partially encoded, even if the data sent to be encoded is less than the maximum capacity of the tag.
Both media and RFID calibration was done before, tried with 2 printers the result was the same.
 
Any help is really appreciated.
 
Regards,
Levente Boncidai.