Hi,
I am using a iMZ320 printer with the default out of the box settings i.e. no configuration. I am using it with a lumia phone through bluetooth.
It prints fine for most receipts but for receipts that are long...it stops midway through the printing. It seems to stop at the same position everytime for individual receipts. Is there a default character limit set for line printing (which is the default config on the printer I believe)? Or is there something else I should be looking at?
Thanks for any help.
Kieran
Zebra iMZ320 - line printing - stops printing midway |
1 Replies
Hi Kieran,
Have you tried entering a wait before closing the connection? Some devices may close the Bluetooth connection before all the data is sent. Another thing to look at is checking if all the data was sent to the printer by putting it into dump mode. Also how long is it printing before it has the issue?
Dump Mode:
1. Turn off the printer.
2. Turn it back on while holding the feed button for 3 seconds.
3. After a few more seconds a very long printout will occur.
4. As soon as it's done printing the words "Press FEED to enter DUMP mode" press feed again
5. Run your app to print and check what gets printed to verify every byte came through
6. Power cycle the printer again to leave dump mode